Table of Contents
Advertisement
Upgrading the TDP-P4 software
To upgrade the TDP-P4 software, you need the M1-A cable (210-0185-xx) that ships with the projector.
SPECIAL NOTE
The computer you use to upgrade the software on the TDP-P4 must run Windows 98
and must have an available USB connector.
Connect the projector to the computer with the M1-A cable
5
Plug the M1-A cable into the projector and computer as shown in the illustration below. You don't
need to plug in the monitor cable.
6
Plug the power cord into the projector and into a power source.
Now you're ready to upgrade the software.
Upgrade the software
1
Open Windows Explorer, navigate to the batch file, then double-click the FlashUSB utility.
TDP-P4 Service Manual
66
Advertisement
Table of Contents
