Table of Contents
Advertisement
5
Use a Torx T-8 screwdriver to remove the four M2.5x6 screws that attach the power supply to the
bottom case.
6
Lift the power supply from the bottom case.
7
If you are replacing the power supply, carefully remove the power supply insulator (505-0889-
xx) from the bottom of the power supply.
Assembly Notes
♦
Before replacing the power supply insulator, make sure it is in good condition. There should be no
holes or tears in the top or bottom. If you observe damage, replace the insulator.
TDP-P4 Service Manual
57
Advertisement
Table of Contents
