Toshiba TDP-P4 Service Manual page 36

Assembly Notes
♦
Ensure that the color wheel shroud is properly secured to the controller ECA. Three tabs on the
shroud engage the edge of the slot on the controller ECA.
♦
As you place the controller over the optical engine, make sure the color wheel fits inside the shroud.
Hold the color wheel cable out of the way (see photo above).
♦
Make certain that the connector on the bottom side of the controller ECA aligns properly with the
connector on the optical engine. After you confirm proper alignment of these connectors, press the
controller ECA down firmly to ensure that they securely engage.
♦
Fasten the controller ECA to the optical engine and bottom case with the six M2.5x6 screws. Tighten
the screws to 3 in.-lbs. (.339 N m).
♦
Reconnect all cables to the controller ECA.
TDP-P4 Service Manual 36