Table of Contents
Advertisement
6
Slide the actuator slightly toward the rear of the projector. Then lift the front of the actuator away
from the bottom case.
Assembly Notes
♦
Make sure that the spring is in position on the actuator before you install the front bezel latch in the
bottom case. The spring should be fully seated on the actuator and rest against the tang in the bottom
case.
♦
Replace the M2.5x6 screw and washer that secure the front bezel latch in the bottom case.
♦
Check the operation of the front bezel latch before you assemble the projector.
TDP-P4 Service Manual
44
Advertisement
Table of Contents
