Table of Contents
Advertisement
I/O EMI Shield
The I/O shield (330-0700-xx) fastens to the M1 video input connector at the rear of the controller ECA.
Contact fingers on the shield drain electro-magnetic interference away from M1 or video source signal
connections to ground.
1
Remove the following items:
Front bezel (see page 11)
Rear bezel (see page 15)
Top case (see page 18)
2
Use a 3/16 inch nut driver to remove the #4-40 jack screws from both sides of the M1 connector.
3
Pull the I/O shield away from the M1 and video connectors on the controller ECA.
TDP-P4 Service Manual
23
Advertisement
Table of Contents
