Toshiba TDP-P4 Service Manual page 40

Assembly Notes
♦
Insert the hook on the front of the ballast in to the eye, then align the screw hole in back. Fasten the
ballast assembly to the bottom case with the M2.5x6 screw. Tighten the screw to 3 in.-lbs. (.338 N m)
CAUTION Avoid damage to the plastic insulation on the side of the ballast assembly when you install it in the
bottom case. The insulation should have no holes or tears. If holes or tears are apparent, do not use
the ballast assembly.
TDP-P4 Service Manual 40