Front Bezel - Toshiba TDP-P4 Service Manual

Dlp data projector

Hide thumbs Also See for TDP-P4:

Table of Contents

Front bezel

The front bezel (505-0814-xx) covers the front of the projector and helps secure the top case to the

bottom case. Hooks on the front bezel engage pins on the top and bottom cases to attach the bezel to the

front of the projector. A spring-loaded latch on the bottom case locks the bezel in position.

NOTE

The front bezel contains a plunger that engages the interlock switch on the ballast assembly. The

lamp will not strike with the front bezel removed unless you defeat the interlock switch. See page

91 for information about powering up the projector with the top removed.

Place the projector on its side to release the front bezel latch. Use your finger or a screwdriver to

slide the latch tab toward the rear of the projector. Hold the latch in position and slide the bezel

slightly toward the side of the projector opposite the lens.

TDP-P4 Service Manual

Table of Contents