Table of Contents
Advertisement
Assembly Notes
♦
Small tabs at the hinge side of the top case engage holes on the bottom case. Make sure that the top
case aligns properly with the bottom case as you close the projector.
♦
Ensure that the keypad cable is properly routed and securely fastened to its ZIF connector on the
controller ECA. The silver contacts at the end of the cable should face toward the top case in the ZIF
connector. Check the ZIF connector latch after you insert the cable to make sure it is locked.
♦
Secure the top case to the bottom case with the M2.5x8 Torx screw. Tighten the screw to 3 in.-lbs.
(.339 N m).
TDP-P4 Service Manual
20
Advertisement
Table of Contents
