Table of Contents
Advertisement
Bottom Case
The bottom case (505-0812-xx) encloses the bottom half of the projector. A new bottom case includes a
certification label, ballast gasket, front bezel latch and elevator. If you need to replace the certification
label, see the Assembly Notes below. When you replace the bottom case, you must first remove all the
parts in the old case, then install them in the new bottom case.
1
Remove the following items:
Front bezel (see page 11)
Rear bezel (see page 15)
Top case (see page 18)
Controller ECA (see page 34)
Optical engine (see page 45)
Power supply (see page 55)
Power supply insulator (see page 57)
Ballast (see page 37)
You are left with the bottom case.
TDP-P4 Service Manual
59
Advertisement
Table of Contents
