Table of Contents
Advertisement
Stitch Type
13. 3-Thread
Narrow Edge
14. 3-Thread
Rolled
Edge
15. 2-Thread
Narrow
Edge
16. 2-Thread
Rolled
Edge
* Depending on the needle positions used, this machine can sew 2-thread and 3-thread standard width 4 mm
over
lock
and a 6 mm wide over
* Also, for overedging heavyweight fabrics, the seam width can be increased still more by turning the
over
lock cutting width dial.
Overlock width
Needle used
Needle thread tension dial
23. STITCH OVERVIEW
*
The settings shown in the table below
be necessary to adjust the thread tension according to the stitch, type of fabric and thread you are using.
*
For best results make tension adjustments in small
* Always test sew on a sample of your fabric before sewing on your garment.
*
Different stitches are obtained by stitch
and the use of the 2-thread converter.
* The thread tension becomes tighter as the dials are turned to higher numbers. The tension settings shown
on this page as well as throughout the Instruction
Overlcok left needle
Overlcok right needle
1-needle 3-thread stitch is for edging lightweight
fabrics. For a beautiful rolled edge, thread the
upper looper with decorative thread and the
needle and lower looper with lightweight regular
thread.
1-needle 3-thread stitch is used for sewing
rolled edge.
1-needle -thread stitch is used for
lightweight fabrics
1-needle -thread stitch is used
lightweight fabrics.
lock
seams.
(See page 1
35
)
4.0 mm
Overlock right needle
page
are our recommendations based on normal conditions. It may
settings
Upper looper
2
2
Blue
increments of no greater than half a number at a time.
with different
tensions,
manual
are suggested guides.
149
Lower looper
edging
for edging
6.0 mm
Overlock left needle
Yellow
needle positions, threading methods,
Page
209
209
209
209
Advertisement
Table of Contents
