Displaying License Usage - Juniper J4350 Getting Started Manual

J4350 and J6350 Services Router Getting Started Guide
The output shows a list of the license usage and a list of the licenses installed on
What It Means
the Services Router. Verify the following information:

Displaying License Usage

Verify that the licenses fully cover the feature configuration on the Services Router.
Purpose
From the CLI, enter the
Action
Sample Output
user@router> show system license usage
The output shows a list of the licenses installed on the Services Router and how
What It Means
they are used. Verify the following information:
138
Verifying J-series License Management
License identifier: G03000002224
State: valid
License version: 2
Valid for device: JN001875AB
Features:
dlsw - Data-Link Switching (DLSw) protocol
License identifier: G03000002225
State: valid
License version: 2
Valid for device: JN001875AB
Features:
j-flow - J-FLOW traffic analysis (CFLOW reporting)
Each license is present. Licenses are listed in ascending alphanumeric order
by license ID.
The state of each license is
A state of indicates that the license key is not a valid license key. Either
invalid
it was entered incorrectly or it is not valid for the specific device.
The feature for each license is the expected feature. The features enabled are
listed by license. An all-inclusive license has
All configured features have the required licenses installed. The
column must show that no licenses are required.
show system license usage
Licenses
Feature name
j-flow
bgp-reflection
dlsw
Each licensed feature is present. Features are listed in ascending alphabetical
order by license name. The number of licenses is shown in the third column.
Verify that the appropriate number of licenses are installed.
.
valid
All features
command.
Licenses Licenses
used installed
0 0
1 1
1 1
listed.
Licenses needed
needed
1
0
0