Field-Replaceable Pims - Juniper J4350 Getting Started Manual

Table 13: PIM Terms (continued)
Term
dial-on-demand-routing
(DDR) backup
dialer watch
"dying gasp" notification
ePIM
floating static route
ISDN S/T interface
ISDN U interface
plain old telephone
service (POTS)

Field-Replaceable PIMs

PIMs are removable and insertable only when the Services Router is powered off.
You can install a PIM into one of the six slots in the router chassis. If a slot is not
occupied by a PIM, a PIM blank panel must be installed to shield the empty slot and
to allow cooling air to circulate properly through the router.
These Services Routers support the types of PIMs summarized in Table 14 and
described in the following sections:
Definition
Feature that provides a J-series Services Router with full-time connectivity across
an ISDN line. When routes on a primary serial T1, E1, T3, E3, Fast Ethernet, or
PPPoE interface are lost, an ISDN dialer interface establishes a backup connection.
To save connection time costs, the Services Router drops the ISDN connection after
a configured period of inactivity. Services Router with ISDN interfaces support two
types of dial-on-demand routing backup: on-demand routing with a dialer filter and
dialer watch. See also dialer filter; dialer watch .
Dial-on-demand routing (DDR) backup feature that provides reliable connectivity
without relying on a dialer filter to activate the ISDN interface. The ISDN dialer
interface monitors the existence of each route on a watch list. If all routes on the
watch list are lost from the routing table, dialer watch initiates the ISDN interface for
failover connectivity. See also dial-on-demand routing backup .
Ability of a Services Router with a digital subscriber line (DSL) connection that
has lost power to send a message informing the attached DSL access multiplexer
(DSLAM) that it is about to go offline.
Enhanced PIM. A particular type of high-speed PIM, such as the Gigabit Ethernet ePIM
or 4-port Fast Ethernet ePIM, which can be inserted only in high-speed slots (slots 3
and 6 on a J4350 Services Router, or slots 2, 3, 5, and 6 on a J6350 Services Router).
Route with an administrative distance greater than the administrative distance of the
dynamically learned versions of the same route. The static route is used only when
the dynamic routes are no longer available. When a floating static route is configured
on an interface with a dialer filter, the interface can be used for backup.
Interface between an ISDN network and a network termination device consisting of
two twisted pairs, one each for transmitting and receiving. The S/T interface usually
resides in the customer premises and operates at 192 Kbps, of which ISDN traffic
accounts for 144 Kbps.
Single twisted–pair interface line connecting the customer premises unit in an ISDN
network to the central office. A U interface runs at 144 Kbps (128 Kbps for two B
channels and 16 Kbps for the D channel).
Standard telephone service that allows limited speed and bandwidth of 52 Kbps,
which is also know as public switched telephone network (PSTN).
Field-Replaceable PIM Summary on page 30
Gigabit Ethernet ePIMs on page 31
Physical Interface Modules Overview
Field-Replaceable PIMs
29