System Maintenance; General Maintenance - Spirit CU 900 LED User Manual

SYSTEM MAINTENANCE

The console has built-in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance Mode, pedal the bike and press and hold down
the Start, Stop and Enter keys. Keep holding the keys down for about 5 seconds and the
Message Center will display Maintenance Mode. Press the Enter key to access the menu below:
1. Key Test (Will allow you to test all the keys to make sure they are functioning)
2. Display Test (Tests all the display functions)
3. Sleep Mode (Turn on to have the console power down automatically after 20 minutes of
inactivity)
4. Odometer Reset (Resets the odometer)
5. Units (Sets the display to read out in English or Metric display measurements)
6. Speaker (Turns off the speaker so no beeping sound is heard)
7. Brake Test (Tests the brake resistance)
8. Sensor Test (Tests the speed sensor function)
9. Unit Type (Sets machine type; Bike or Elliptical )

GENERAL MAINTENANCE

In order to maintain the safety level and the ease of use of the device, the below instructions for
general maintenance should be followed:
Daily (by the user)
Computer, upholstery, handgrips
Clean the device after every workout with a soft cloth, so that the following users have a clean
device available.
Daily (by staff)
Complete unit
Complete cleaning and removal of all traces of sweat with a suitable cleaning cloth to ensure a
clean, efficient device.
58