Hitachi L100 Instruction Manual page 87

Output Terminal Configuration
Func.
Code
C21
C22
C23
Func.
Code
C31
C32
C33
Toll Free: voice: 1-877-539-2542 fax: 1-800-539-2542 www.mgitech.com
Technologies Inc.
The inverter provides configuration for logic (discrete) and analog outputs, shown in the
table below.
"C" Function
Name
Terminal 11 function Select function for terminal 11,
(logical) 6 options (see next section)
Terminal 12 function Select function for terminal 12,
(logical) 6 options (see next section)
Terminal FM function Select function for terminal
(analog) FM, 3 options (see next
section)
The output logic convention is programmable for terminals 11 and 12. The open-collec-
tor output terminals 11 and 12 default to normally open (active low), but you can select
normally closed (active high) for terminals 11 and 12 in order to invert the sense of the
logic. The relay already has normally open and normally closed contacts, but you can
invert the logic sense of these as well.
"C" Function
Name
Terminal 11 active Select logic convention, two
state option codes:
00... normally open [NO]
01... normally closed [NC]
Terminal 12 active Select logic convention, two
state option codes:
00... normally open [NO]
01... normally closed [NC]
Alarm relay active Select logic convention, two
state option codes:
00... normally open [NO]
01... normally closed [NC]
Run-
time
Description
Edit
Run-
time
Description
Edit
3–31
L100 Inverter
Defaults DOP,DRW,DOP+
EU/ Func.
Units Name
US Code
01 — F-35 OUT-TM
1
00 — F-35 OUT-TM
2
00 — F-37 MONITOR
Defaults DOP,DRW,DOP+
EU/ Func.
Units Name
US Code
00 — F-35 OUT-TM
O/C-1
00 — F-35 OUT-TM
O/C-2
01 — F-35 OUT-TM
O/C-RY