Hitachi L100 Instruction Manual page 85

Option
Code
00
01
02
03
04
05
06
09
11
12
13
Toll Free: voice: 1-877-539-2542 fax: 1-800-539-2542 www.mgitech.com
Technologies Inc.
Summary Table - this table shows all fifteen intelligent input functions at a glance.
Detailed descriptions of these functions, related parameters and settings, and example
wiring diagrams are in Chapter 4, starting on page 4–6.
Input Function Summary Table
Terminal
Function Name
Symbol
FW Forward Run/Stop
RV Reverse Run/Stop
CF1 Multi-speed select,
Bit 0 (LSB)
CF2 Multi-speed select,
Bit 1
CF3 Multi-speed select,
Bit 2
CF4 Multi-speed select,
Bit 3 (MSB)
JG Jogging
2CH 2-stage Acceleration
and Deceleration
FRS Free-run Stop
EXT External Trip
USP Unattended Start
Protection
Description
ON Inverter is in Run Mode, motor runs forward
OFF Inverter is in Stop Mode, motor stops
ON Inverter is in Run Mode, motor runs reverse
OFF Inverter is in Stop Mode, motor stops
ON Binary encoded speed select, Bit 0, logical 1
OFF Binary encoded speed select, Bit 0, logical 0
ON Binary encoded speed select, Bit 1, logical 1
OFF Binary encoded speed select, Bit 1, logical 0
ON Binary encoded speed select, Bit 2, logical 1
OFF Binary encoded speed select, Bit 2, logical 0
ON Binary encoded speed select, Bit 3, logical 1
OFF Binary encoded speed select, Bit 3, logical 0
ON Inverter is in Run Mode, output to motor
runs at jog parameter frequency
OFF Inverter is in Stop Mode
ON Frequency output uses 2nd-stage accelera-
tion and deceleration values
OFF Frequency output uses standard acceleration
and deceleration values
ON Causes output to turn off, allowing motor to
free run (coast) to stop
OFF Output operates normally, so controlled
deceleration stops motor
ON When assigned input transitions Off to On,
inverter latches trip event and displays E12
OFF No trip event for On to Off, any recorded trip
events remain in history until Reset
ON On powerup, the inverter will not resume a
Run command (mostly used in the US)
OFF On powerup, the inverter will resume a Run
command that was active before power loss
3–29
L100 Inverter