Teledyne 4250 Installation And Operation Manual page 168

4250 Flow Meter
Appendix B Programming Worksheets
B-2
8. Zero Level Offset = Feet (or Meters)_________
9. Zero Flow on Error? Yes
10. D.O./ph Reading Interval: Continuous, 15 Sec, 30 Sec,
1Min, 2 Min, 5 Min______________________
11. YSI 600 Reading Interval: Continuous, 15 Sec, 30 Sec, 1
Min, 2 Min, 5 Min_________________
12. For reference only after installation, copy the values shown
on the flow meter: Signal Strength__________% Spectrum
Strength__________%
13. Velocity Enable/Alarm: Hysteresis__________Ft/S (or
Meters/Second)
14. Level Enable/Alarm: Hysteresis ________Feet (Or Meters)
15. Flow Rate Enable/Alarm Hysteresis _______Units______
16. Temperature Enable/Alarm Hysteresis ______Deg. F (C)
17. pH Enable/Alarm Hysteresis ________pH units.
18. D.O. Enable/Alarm Hysteresis ________ppm.
19. YSI-pH Enable/Alarm Hysteresis ________pH units.
20. YSI-D.O. Enable/Alarm Hysteresis ________ppm/mg./L
21. YSI-Conductivity Enable /Alarm Hysteresis_______mS/cm
22. YSI-Temperature Enable/Alarm Hysteresis______Deg.
23. Optional Outputs: 4-20 Ma Output, Serial Output, Alarm
Box, Mechanical Totalizer
24. Report Setup, Report A: Flow, D.O./pH, YSI 600, Sample
History, Flow Meter History
25. Level In Report:
26. Velocity In Report:
27. Flow Rate In Report:
28. Rainfall In Report:
29. pH or D.O. In Report:
30. Temperature In Report:
31. YSI 600 Data in Report:
32. Sample History In Report:
33. Flow Meter History In Report:
34. Report Setup, Report B: Flow, D.O./pH, YSI 600, Sample
History, Flow Meter History
35. Level In Report:
36. Velocity In Report: Yes
37. Flow Rate In Report:
38. Rainfall In Report:
39. pH or D.O. In Report:
40. Temperature In Report:
41. YSI 600 Data in Report:
No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
Yes No
No
Yes No
Yes No
Yes No
Yes No
Yes No