Teledyne 4250 Installation And Operation Manual page 190

4250 Flow Meter
Appendix D Material Safety Data Sheets
Multisorb Technologies, Inc
The HMIS rating information is intended solely for the use of individuals trained in the
use of the HMIS rating system.
The NPCA specifically recommends that prepares of MSDSs should not place HMIS
PPE designation codes on the MSDSs or labels that leave the facility as it is not known
the conditions under which the customer will use this product.
This MSDS was prepared by: George E. Mckedy
This data and recommendations presented in this data sheet concerning the use of our product and the materials
contained therein are believed to be correct but does not purport to be all inclusive and shall be used only as a guide.
However, the customer should determine the suitability of such materials for his purpose before adopting them on a
commercial scale. Since the use of our products is beyond our control, no guarantee, expressed or implied, is made and
no responsibility assumed for the use of this material or the results to be obtained therefrom. Information on this form
is furnished for the purpose of compliance with Government Health and Safety Regulations and shall not be used for
any other purposes. Moreover, the recommendations contained in this data sheet are not to be construed as a license to
operate under, or a recommendation to infringe, any existing patents, nor should they be confused with state, municipal
or insurance requirements, or with national safety codes.
D-6
Silica gel, Indicating
HMIS Hazardous Materials Identification System
HMIS Rating
Health
Flammability
Physical
Senior Applications Development Specialist
Multisorb Technologies, Inc.
February 14, 2009 Page 5 of 5
1
0
0