Receiving An Individual Call - Furuno FS-5070 Operator's Manual

No response! Try calling again?
Re-send call: Push the ENTER knob followed by pressing the CALL key.
Cancel call: Press the CANCEL key to go to DSC screen.
5.1.2

Receiving an individual call

Acknowledgement is able or unable depending on the comply-type setting (see section
6.11). The relationship between comply type and able/unable acknowledge is as shown in
the table below.
Setting for ACK/SQ key
AUTO ACK
MANUAL ACK
Note: The handset must be on hook to enable automatic acknowledge.
Sending automatic acknowledge (ACK BQ) with comply type "ABLE"
When an individual call is received and the automatic acknowledge feature is active (AUTO
ACK) and the comply type is "ABLE," the display shown below appears. This display
indicates that the auto acknowledge (ACK BQ) call is being sent.
Able acknowledge
message in progress!
DESTINATION ID:
PRIORITY :
TELEPHONE
DSC FREQ :
TIME TO GO:
It takes about seven seconds to transmit the call, after which the audio alarm sounds and
the following message appears.
Able acknowledge
message transmitted.
CANCEL: STOP ALARM
PRIORITY: ROUTINE TX: 2138.0 kHz
TELEPHONE
1. Press the CANCEL key to silence the alarm. The following display appears.
Can send ABLE acknowledge
automatically
Send ABLE
manually
123456789
ROUTINE
2138.0 kHz
2177.0 kHz
6S
RX: 2138.0 kHz
5. ROUTINE MESSAGE CALLING, RECEVING
ABLE
Can send UNABLE
acknowledge automatically.
acknowledge Send UNABLE acknowledge
manually
UNABLE
5-7