Furuno FS-5070 Operator's Manual page 65

13.Press the CALL key to send the individual call (transmission time: about seven seconds).
The display shows the message "Individual routine message in progress!" while the call
is being sent.
Individual routine
message in progress!
DESTINATION ID:
PRIORITY :
TELEPHONE
DSC FREQ :
TIME TO GO:
After the call is sent, the equipment waits for acknowledgement of the call, showing the
display below.
Waiting for
acknowledgement.
DESTINATION ID:
PRIORITY : ROUTINE
TELEPHONE
DSC FREQ :
TIME TO GO: 4M30S RESENDING
The timer starts counting down the maximum time to wait for acknowledgement, five
minutes. One of the following three messages appears. ("No response! Try calling again?"
appears after the timer counts down to zero. It means the receiving station did not respond.)
Able acknowledge
message received.
CANCEL: STOP ALARM
PRIORITY : ROUTINE
TELEPHONE 2138.0 kHz
Able acknowledge call received
14. Do one of the following depending on the message shown in step 12.
Note: When the channel is in use,
123456789
ROUTINE
2138.0 kHz
2177.0 kHz
7S
123456789
2138.0 kHz
2177.0 kHz
Unable acknowledge
message received.
CANCEL: STOP ALARM
SENDER ID
PRIORITY
Unable acknowledge call received
5. ROUTINE MESSAGE CALLING, RECEVING
"CH BUSY" appears at the
lower left-hand side of the
screen.
Press CALL key for forced
transmission.
TELEPHONE
:
123456789
: ROUTINE
(appears when the timer counts to "zero")
No response!
Try calling again?
DESTINATION ID:
123456789
PRIORITY : ROUTINE
2138.0 kHz
DSC FREQ :
2177.0 kHz
RESEND
No response from station
5-5