Furuno FS-5070 Operator's Manual page 70

Ssb radiotelephone
Hide thumbs Also See for FS-5070:
Table of Contents

Advertisement

5. ROUTINE MESSAGE CALLING, RECEVING
Compose msg.
MSG TYPE:
ABLE
ACKNOWLEDGEMENT
STATION ID: 121234567
COMM MODE: TELEPHONE
COMM FREQ: CH401
DSC FREQ:
4
M-INTL
GO TO VIEW
5. Press the CALL key to send the acknowledge call. The display changes as below.
Able acknowledge
message in progress!
DESTINATION ID
PRIORITY
TELEPHONE
DSC FREQ :
TIME TO GO:
6. After the call is completely sent (transmission time: 7 sec.), push the CANCEL key twice
to show the radiotelephone screen (if the communications mode is telephone).
7. You can begin voice communications by radiotelephone. For NBDP operation, do the
following:
Communicating by NBDP Terminal Unit
After acknowledging an individual call, do the following to communicate by NBDP Terminal
Unit. The control unit's display shows "OCCUPIED" and the Tx and Rx frequencies. The
message from the other party appears on your NBDP Terminal Unit.
1. After receiving the message from the other party, type your message and transmit it.
2. Press the function key F10 (BREAK) to disconnect the line.
Manually acknowledging individual call with "UNABLE"
When an individual call is received and the equipment is set up with manual acknowledge,
the alarm sounds and the display shows the message "Individual xxx (priority name)
message received."
Individual routine
message received.
Ack Required.
CANCEL: STOP ALARM
TELEPHONE
1. Press the CANCEL key to silence the alarm. The display changes as below.
5-10
:
121234567
: ROUTINE
CH 401
4208.0
kHz
7S
CH 401

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fs-1570Fs-2570

Table of Contents