Furuno FS-5070 Operator's Manual page 175

Compose msg.
MSG TYPE : TEST MESSAGE
STATION ID :
001234567
PRIORITY : SAFETY
DSC FREQ :
GO TO VIEW
9. Press the CALL key to send the test call (transmission time: about seven seconds).
10. The display shows "Test message in progress!" while the test call is being transmitted.
Test
message in progress!
DESTINATION ID
PRIORITY
DSC FREQ :
TIME TO GO :
After the test call is completed, the following message appears.
Waiting for test
acknowledgement.
DESTINATION ID
PRIORITY
DSC FREQ :
TIME TO GO : 4M12S RESENDING
One of the following displays appears. ("No response! Try calling again?" appears when the
timer counts down to zero, meaning no response from station.)
Test acknowledge
message received.
CANCEL: STOP ALARM
Test acknowledge received
11. Do the either way depending on the message shown in step 10.
Test acknowledge message received
The audio alarm sounds; press the CANCEL key to silence the alarm. The display changes
as below.
2187.5 kHz
:
001234567
:SAFETY
2187.5 kHz
7S
: 001234567
: SAFETY
2187.5 kHz
11. MAINTENANCE & TROUBLESHOOTING
No response!
Try calling again?
DESTINATION ID:
001234567
PRIORITY: SAFETY
DSC FREQ :
2187.5 kHz
RESEND
No response to test call
11-7