Receiving A Group Call - Furuno FS-5070 Operator's Manual

5. ROUTINE MESSAGE CALLING, RECEVING
Sending message by NBDP Terminal Unit
The message "STATION ENTRY COMPLETED FROM DSC. Press any key to escape."
Appears on the NBDP's display.
1. Press any key on the NBDP Terminal Unit to erase the message.
2. Press the function key F3 on the keyboard of the NBDP Terminal Unit to show the
Operate menu.
3. Choose "Call Station" and then press the Enter key.
4. "DSC" is selected; press the Enter key. "Connect" appears in reverse video.
5. Type and transmit your message.
6. When you have finished sending your message, press the F10 key to disconnect the
line.
5.2.2

Receiving a group call

Group ID must be registered in order to receive a group call.
The audio alarm sounds and the display shows "Group message received" when a group
call is received.
Group
message received.
CANCEL: STOP ALARM
PRIORITY: ROUTINE
TELEPHONE
1. Press the CANCEL key to silence the alarm. The display changes as below.
*
Received message
MAR-23-2006-23:59
GROUP MESSAGE
SENDER ID :
PRIORITY:
ROUTINE TX: 2164.0 kHz
TELEPHONE
GO TO VIEW
2. Press the CANCEL key to go to the radiotelephone screen. Watch on the working
frequency. If there is the difference between the registered frequency and used
frequency to receive, the following screens appear. Choose Agree for the voice
communication, or Disagree when you do not change the frequency.
5-14
TX: 2164.0 kHz
RX: 2164.0 kHz
*
123456789
RX: 2164.0 kHz
2M14S