Changing the output volume level
Users can set each local audio output's volume level through a range of zero steps
of attenuation (full attenuation, minimum volume) to 64 steps of attenuation (no
attenuation, full volume) from the I/O Settings page.
Change an output's audio volume setting as follows:
1.
Click the desired output's Volume drop box. A drop-down scroll box appears
(figure 6-16).
Figure 6-16 — Volume drop box
2.
Click and drag the slider or click on the scroll up
button until the desired value is visible.
N As an alternative to steps 1 and 2, or to listen to the audio as you make
adjustments, click on the up
N The table on the next page defines the value of each audio volume step.
Muting and unmuting an audio or RS-232 output
Mute and unmute an audio or RS-232 output by clicking the associated
Audio Mute button. Each click toggles the mute status.
MTPX Plus Twisted Pair Matrix Switchers • HTML Operation
button or the scroll down
button or down
button.
6-19