Connecting The Power Cords; Completing The Installation - Sun Microsystems Sun StorEdge A3500 Manual

2.7

Connecting the Power Cords

Tools: None
Equipment: AC power cords (shipped with the controller module)
1. Make sure the power switches for both power supplies in the controller module
are off (
2. Determine how the power cords will be routed to the power sequencers.
Refer to the Sun StorEdge A3500/A3500FC Hardware Configuration Guide (805-4981).
Skip to Step 6 if you are installing the controller module in a StorEdge expansion
cabinet.
3. Retrieve the power cords from the controller module shipping container.
4. Facing the rear of the cabinet, plug the power cords into AC power sequencer
outlets in the cabinet.
Note – The cords must be plugged into one or more of the four right outlets to
ensure that the controller module is powered on after the disk drive trays.
5. Secure the cables to the inside of the cabinet (left or right) with tie wraps.
This will keep them from blocking the air flow to the back of the controller module.
6. Connect the power cords to the controller module.
2.8

Completing the Installation

Proceed to Chapter 3 "Operating the Controller Module" and follow the instructions
in Section 3.1 "Powering On the Controller Module and System."
).
FIGURE 2-9
Chapter 2 Installation 2-25