2.1.1
Connecting the AC Power Cord
For detailed instructions on how to connect the AC power cord to the front power
sequencer in your expansion cabinet, refer to the Sun StorEdge Expansion Cabinet
Installation and Service Manual (805-3067) and to Section 2.7 "Connecting the Power
Cords" on page 2-25 in this manual.
Tip – After opening the rear door of the expansion cabinet, be sure to remove both
the front and rear trim panels. Removing the front panel enables you to connect the
female end of each AC power cord to the power sequencer connectors behind the
front trim panel (
FIGURE 2-1
).
FIGURE 2-1
Connecting the AC Power Cord
Front Power Sequencer
Front Trim Panel Removed
Chapter 2
Installation
2-3