Figure 6-8 Controller Card Cage Side Vent - Sun Microsystems Sun StorEdge A3500 Manual

6. Remove the side vent from the old controller card cage (
There is one screw securing the vent to the card cage structure. You will reuse this
vent in Step 11.
Side vent
Controller Card Cage Side Vent
FIGURE 6-8
7. Unpack the new controller card cage.
8. With the back panel facing the rear shield, set the new controller card cage into
the chassis (reverse the steps in
9. Grasp the top, front edge of the card cage and push the unit toward the back until
the back panel rests firmly against the rear shield.
As you slide the card cage backward, keep the battery harness flat against the
bottom of the chassis so it does not get pinched between the controller card cage and
the rear shield.
Note – There are four holes in the bottom frame of the controller card cage that fit
over four mounting pins in the top of the battery retainer shelf (
you slide the controller card cage into place, you will feel it drop down when the
pins slip into these holes.
10. Secure the eight screws that hold the controller card cage in the chassis
( ).
FIGURE 6-5
11. Insert and secure the side vent into the slot on the right side of the controller card
cage with the mounting screw (
12. Connect the battery and power harnesses (
).
FIGURE 6-7
).
FIGURE 6-8
FIGURE 6-6
Chapter 6 Servicing Other Components
).
FIGURE 6-8
). When
FIGURE 6-7
).
6-13