3. Disconnect the battery and power harnesses on the rear of the controller module.
shows the battery and power harnesses on the rear of a SCSI controller
FIGURE 6-6
module.
Disconnect all three harnesses by unlocking and opening the latches on each side of
the connector. After you disconnect each harness, close the latches to keep them
from breaking when you remove the controller card cage.
Note – Make sure that the connector end of the battery harness is outside the
chassis and lying flat across the bottom of the access hole in the rear shield.
Power harnesses
Battery harnesses
Rear
Battery and Power Harnesses on a SCSI Controller Module
FIGURE 6-6
Chapter 6
Servicing Other Components
6-11