4. Remove the failed power supply (
a. Lift the lever on the pull ring to unlock the power supply canister.
b. Pull the failed power supply out of the controller module.
Pull ring
Removing a Power Supply Canister
FIGURE 7-2
5. Unpack the new power supply.
6. Insert the new power supply into the empty slot, pushing it all the way in until
the lever locks into place.
7. Plug in the power cord and turn the power switch to the On position (
8. Check the power supply canister and other controller module LEDs for faults.
).
FIGURE 7-2
Chapter 7
FIGURE 7-1
Power Subassemblies
).
7-5