Figure 2-10 The Front Panel Of The Controller Module (Upgrade) - Sun Microsystems Sun StorEdge A3500 Manual

FIGURE 2-10
2. Remove the controller canister.
See Section 6.3.1 "Removing and Replacing a Controller" on page 6-5.
3. Replace the existing controller canister with the A3500FC controller canister.
See Section 6.3.1 "Removing and Replacing a Controller" on page 6-5.
4. Remove the four mounting screws from each side of the battery canister.
See
FIGURE 5-4
5. Use a #2 Phillips screwdriver to loosen and remove the four screws that secure the
chassis to the mounting rails, two screws on each side at the back of the controller
module chassis.
See
FIGURE 5-5
6. Slide the controller module backward until you feel resistance (approximately one
inch).
7. Mount a cable clip on the top, rear flange of the right mounting rail (towards the
rear).
See
FIGURE 2-11
included in the A3500FC controller upgrade kit.)
2-16 Sun StorEdge A3500/A3500FC Controller Module Guide • August 1999
Front Panel
The Front Panel of the Controller Module (Upgrade)
on page 5-5.
on page 5-6.
for the location of the cable clip on the mounting rail. (Cable clips are
Notch for fibre
optic cables