System Configuration Via Profinet/Profibus With Cm - Siemens SIMATIC MV500 Operating Instructions Manual

Network and system integration

4.2 System configuration via PROFINET/PROFIBUS with CM

NOTICE
Simultaneous use of both Ethernet interfaces with MV550/MV560
Note that both Ethernet interfaces "X1 LAN1" and "X2 LAN2" must be connected to
physically separated networks if you want to use both interfaces at the same time. A purely
logical separation using different subnets is not sufficient and can cause network problems
in some cases.
4.2 System configuration via PROFINET/PROFIBUS with CM
①
②
Figure 4-1
System characteristics
• The PROFINET/PROFIBUS connection is made via the CM interface of the optical reader and
a communication module.
• PROFINET IO/PROFIBUS DP-V1 is connected to an S7 controller.
94
Optical sensor or light barrier (for trigger signal)
Object with code
Example: System configuration via PROFINET IO/PROFIBUS DP-V1 with communication
module
Operating Instructions, 03/2021, C79000-G8976-C494-05
SIMATIC MV500