Siemens SIMATIC MV500 Operating Instructions Manual page 230

Service and maintenance
10.1 Error and diagnostics messages
Error code Error message
(%c) (%s)
0014 Found m instead of the expected number of
1D/2D codes in step n
0015 Maximum number of codes per image (m) was
exceeded in step n
0016 The maximum amount of data which can be de-
coded was exceeded in code m of step n
0017 Trigger during image acquisition
0018 Step timeout reached in step n
1006 No text found in step n
1007 Text length is less than minimum specified in step
n
1008 Text length exceeds the maximum specified in
step n
1009 Quality violates limit values in step n
1010 Match failed in step n
1011 Reference text missing in step n
4700 Verification failed in step n
4701 Verification for code type found in step n not
supported
4707 Mean light outside of range in step n: Maximum
exposure time reached
4708 Mean light outside of range in step n: Cycle time
limit of the automatic exposure control reached
4709 Mean light outside of range in step n
230
Description
Only m codes instead of the expected number of
codes were found in step # n during multicode decod-
ing.
More than the maximum possible number of codes per
image was found with multicode decoding (50,
MV500 U: 150).
A maximum of 3001 bytes can be decoded per step.
This length was exceeded in step #n for code #m.
The trigger signal was applied during image acquisi-
tion. In this case, no additional image acquisition is
started. Instead, image acquisition and processing are
continued and an "N_OK" result is generated immedi-
ately upon completion.
In step #n, the defined time limit was reached.
OCR: No text was found in step #n.
OCR: The text found in step #n is shorter than the
minimum setting.
OCR: The text found in step #n is longer than the max-
imum setting.
OCR: The text found in step #n is below the quality
threshold setting.
OCR: The match performed in step #n was not success-
ful.
OCR: There is no string specification available for
step #n.
The read code could not be verified.
The selected verification method is not supported for
the code type found in step #n.
The average brightness needed for ISO/IEC 29158 is
outside the valid range (see Error code 4709).
The specified maximum value for the exposure time
was reached during automatic exposure control.
To resolve this error:
1. Use brighter lighting or enlarge the aperture of the
objective (lower aperture number).
2. Perform a new calibration.
The average brightness needed for ISO/IEC 29158 is
outside the valid range (see Error code 4709).
The automatic exposure control was unsuccessful
because the necessary decodings could not be com-
pleted within the time limit.
To resolve this error:
• Reduce the exposure ROI of the program.
• Increase the time limit of the exposure control.
• Also ensure that the code is completely within the
exposure ROI until conclusion of the image acquisi-
tion process.
The average brightness needed for ISO/IEC 29158 is
outside the valid range (70% to 86%) in step #n.
Operating Instructions, 03/2021, C79000-G8976-C494-05
SIMATIC MV500