Siemens SIMATIC MV500 Operating Instructions Manual page 232

Hide thumbs Also See for SIMATIC MV500:
Table of Contents

Advertisement

Service and maintenance
10.1 Error and diagnostics messages
Error code
Error message
(%c)
(%s)
5004
Too few objects found in step n: Rotation range
exceeded
5005
Too few objects found in step n: Scaling range
exceeded
5006
Too few objects found in step n: Contours not
adequate
5008
Too few objects found in step n: Details not rec-
ognized
5009
Too few objects found in step n: Outline not rec-
ognized
5010
Too few objects found in step n: Clear percentage
violated
5011
Too many objects found in step n
5012
Quality too poor in step n
5013
Average Quality too poor in step n
5014
Match error tolerance exceeded in step n
5015
Position tolerance exceeded for object m in step n
5016
Rotation tolerance exceeded for object m in step n Locator: The rotation angle of object m in step #n is
5017
Too few objects found in step n: Alignment failed
232
Description
Locator: The number of objects found in step #n is
lower than the set minimum. At least one object was
rejected because it did not comply with the rotation
constraint.
Locator: The number of objects found in step #n is
lower than the set minimum. At least one object was
rejected because it did not comply with the scale con-
straint.
Locator: The number of objects found in step #n is
lower than the set minimum. At least one object was
rejected because insufficient contours were found.
Locator: The number of objects found in step #n is
lower than the set minimum. At least one object that
was identified at the outline level was rejected at the
detail level.
Locator: The number of objects found in step #n is
lower than the set minimum. No object was found at
the outline level.
Locator: The number of objects found in step #n is
lower than the set minimum. At least one object was
rejected because it did not comply with the clear per-
centage constraint.
Locator: The number of objects found in step #n is
higher than the set maximum.
Locator: The objects found in step #n are below the set
quality threshold.
Locator: The objects found in step #n are below the set
average quality threshold.
Locator: The match performed in step #n was not
successful because the number of match errors was
higher than the maximum number permitted.
Locator: The position of object m in step #n is outside
the maximum permitted deviation.
outside the maximum permitted deviation.
Locator: The number of objects found in step #n is
smaller than the set minimum. At least one object was
filtered out through the "Alignment".
Operating Instructions, 03/2021, C79000-G8976-C494-05
SIMATIC MV500

Advertisement

Table of Contents
loading

Table of Contents