Height Adjustment - Invacare Pronto M71 Service Manual

Make sure the detent balls are engaged with the outer edge of the tube - otherwise,
injury and/or damage may result.
2. Adjust footboard to one of three mounting positions.
3. Install the quick release pin. Make sure the detent balls are engaged with the outer
edge of the tube.

Height Adjustment

NOTE: For this procedure, refer to FIGURE 7.11.
1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame.
2. Remove mounting screw, washer, bushing, locknut and two nylon washers that secure
the footboard to the footboard support.
3. Align footboard mounting holes with one of three height adjustment mounting holes.
4. Using the mounting screw, washer, bushing, locknut and two nylon washers, secure
the footboard to the footboard support.
5. Insert footboard support, with footboard attached, into the wheelchair frame and
align wheelchair frame mounting holes with the desired depth adjustment mounting
holes in the footboard assembly.
Make sure the detent balls of the quick-release pin are fully released beyond the
outer edge of the tube before operating the wheelchair. Otherwise, injury and/or
damage may result.
Keep detent balls clean.
6. Using the quick release pin, secure the footboard assembly to the wheelchair frame.
Make sure the detent balls are engaged with the outer edge of the tube.
Wheelchair Frame
Mounting Hole
Quick Release Pin
Footboard Support
Bushing
FIGURE 7.11 Depth Adjustment/Height Adjustment
Part No 1118377
All manuals and user guides at all-guides.com
SECTION 7—FRONT RIGGINGS/FOOTBOARD
WARNING
WARNING
Depth Adjustment Holes
Height Adjustment Holes
Nylon Washers
Locknut
73
Washer
Mounting Screws
Footboard
Bottom view
Quick Release
Pin
Detent Balls
Outer Edge of
Tube
Pronto® M71™