Replacing Heel Loops; Raising/Lowering Elevating Front Riggings; Adjusting/Replacing Telescoping Front Rigging Supports; Van Seat - Invacare Pronto M71 Service Manual

SECTION 7—FRONT RIGGINGS/FOOTBOARD

Replacing Heel Loops

NOTE: For this procedure, refer to FIGURE 7.4.
1. Note the position of hex bolt, coved washers and locknut for reinstallation.
2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
3. Remove the lower footrest.
4. Remove the mounting screw, spacer
and locknut that secure the existing
heel loop to the lower footrest.
5. Slide the existing heel loop off the
lower footrest.
6. Replace heel loop.
7. Reverse STEPS 1-6 to reassemble.
NOTE: When securing heel loop to lower
footrest, tighten the mounting screw and
locknut until the spacer is secure.

Raising/Lowering Elevating Front Riggings

NOTE: For this procedure, refer to FIGURE 7.5.
1. Perform one of the following:
A. Raising - Pull back on the release
lever and raise front rigging to the
desired height.
B. Lowering - Support front rigging
with one hand away from the
release lever. Push release lever
downward with other hand.
Adjusting/Replacing Telescoping Front Rigging
Supports

Van Seat

NOTE: For this procedure, refer to FIGURE 7.6 on page 69.
NOTE: When adjusting the telescoping front rigging support depth, ensure the footplate does not
interfere with the caster wheel rotation.
NOTE: Telescoping front rigging supports may be extended up to 2-inches from the wheelchair
frame in 1-inch increments. This adjustment does not affect seat depth.
Pronto® M71™
All manuals and user guides at all-guides.com
68
Locknut
Coved
Washer
Lower Footrest
Locknut
FIGURE 7.4 Replacing Heel Loops
FIGURE 7.5 Raising/Lowering Elevating
Front Riggings
Footrest Support
Hex Bolt
Mounting
Screw
Spacer
Heel
Loop
Release
Lever
Part No 1118377