Invacare Pronto M71 Service Manual page 92

SECTION 10—BATTERIES/CHARGER
6. Secure each terminal cap in place with a tie-wrap (use tie-wraps 11-1/2-inches long)
(DETAIL "B" of FIGURE 10.4 or FIGURE 10.5).
NOTE: It will be necessary to trim excess tie-wrap in order to install the battery box top(s).
7. If necessary, install the battery box top(s) using the nylon webbing straps and snug the
adjuster against the box top (Detail "C" of FIGURE 10.4).
8. Position the battery(ies) into the wheelchair. Refer to Installing Batteries on page 89.
NOTE: New Battery(ies) MUST be fully charged before using, otherwise the life of the battery(ies)
will be reduced.
9. If necessary, charge the battery(ies). Refer to Charging Batteries in owner's manual
shipped with wheelchair.
DETAIL "A"
1/4-20 x 7/8-Inch
Hex Flange Screw
U1 Battery
Positive (+) Battery
Terminal/Post
Connect battery
cable(s) ring
terminal(s) to this
side of battery
terminal(s)/post(s)
FIGURE 10.4 Connecting/Disconnecting Battery Cables - Wheelchairs Manufactured Before
Pronto® M71™
All manuals and user guides at all-guides.com
NEGATIVE (-) Battery
Terminal/Post
1/4-20 Hex
Flange Locknut
7/14/03
92
DETAIL "B"
POSITIVE (+) Battery
Terminal/Post
Tie-Wrap
U1
Battery
DETAIL "C"
Nylon
Webbing Strap
NEGATIVE (-) Battery
Terminal/Post
Tie-Wrap
ORANGE
Battery
Terminal Cap
Part No 1118377