SECTION 4—SEAT ASSEMBLY
Back Cane
Cane Bracket
Upper Hex Screw
Washers
Lower Hex Screw
Replacing Seat Positioning Strap
NOTE: For this procedure, refer to FIGURE 4.10.
1. Remove the seat cushion from the seat pan.
2. Move the flip back armrests out of the way. Refer to Adjusting Flip Back Armrests on
page 60.
3. Remove the two mounting screws, locknuts, washers and quick-release pin tabs that
secure the seat positioning straps to the seat frame.
4. Remove the two halves of the seat positioning strap from the rear seat frame.
5. Reposition the two new seat positioning strap inside of the seat frame as shown.
6. Reinstall the two mounting screws and quick-release pin tabs that secure the seat
positioning straps to the seat frame and torque to 75 in-lbs.
7. Reinstall the seat cushion onto the seat pan.
Seat Frame
Mounting Screw
Quick-Release Pin Tab
Pronto® M71™
All manuals and user guides at all-guides.com
Locknuts
Slot
FIGURE 4.9 Removing/Installing the Back Canes
Mounting
Holes
Locknuts
Washers
FIGURE 4.10 Replacing Seat Positioning Strap
Mounting Screw
Seat Frame
Quick-Release Pin Tab
Seat Positioning Strap Halves
42
Part No 1118377