Removing/Installing Side Rails - Invacare Pronto M71 Service Manual

SECTION 4—SEAT ASSEMBLY

Removing/Installing Side Rails

NOTE: For this procedure, refer to FIGURE 4.7 on page 39.
Removing Side Rails
1. Remove both armrests.
2. Remove the two hex screws, washer and lanyard securing the crossbars to the side rail.
3. Loosen, but DO NOT remove, the four hex screws securing the cane brackets to the
side rails.
4. Loosen, but DO NOT remove, the four hex screws securing the front arm sockets to
the side rails.
5. Use a screwdriver to gently tap the two roll pins out of the side rails.
6. Slide both cane brackets (with T-nuts and back canes) out of the slots in the side rails.
7. Slide both front arm sockets (with T-nuts) out of the slots in the side rails.
Pronto® M71™
All manuals and user guides at all-guides.com
Cane
Bracket
Side Rail
Hex Screws
FIGURE 4.6 Adjusting the Seat Depth
38
DETAIL "A" - SEAT
DEPTH
MEASUREMENT
Measure Distance
Front
Arm
Socket
Rear
Arm
Socket
Side Rail
Part No 1118377