Invacare Pronto M71 Service Manual page 96

SECTION 10—BATTERIES/CHARGER
8. Route the battery charger cable to the right side (from the rear of the wheelchair) of
the battery charger body.
9. Connect the battery charge cable to the controller charger cable.
10. Using hook and loop strap provided, wrap the AC cord and secure to back of
wheelchair.
11. Install the rear shroud. Refer to Removing/Installing the Shrouds on page 74.
12. Install the batteries. Refer to Installing Batteries on page 89.
Battery Charger Installed
Battery Charger
Hook and Loop Strap
FIGURE 10.7 Replacing the On-Board Battery Charger
Pronto® M71™
All manuals and user guides at all-guides.com
AC Cord
Battery
Charger
Cable
Hook and
Loop Strap
Battery Charger Removed
Battery Charger
Tie-Wraps
NOTE: Controller charger cable not shown.
96
Hook and Loop Strips
Wheelchair Frame
Tie-Wrap
Part No 1118377