Rear Fuselage And Empennage; Main Gearand Brakes - Raytheon BEECH BARON 58P Maintenance Manual

Raythean
Aircraft
BEECH BARON 58P AND BARON 58TC MAINTENANCE MANUAL
100-HOUR INSPECTION (CONTINUED)
G. REAR FUSELAGE AND EMPENNAGE (Continued)
MECH
INSP
4,
CABLES,
PULLEYS AND
TURNBUCKLES
Check the elevator and rudder
flight control components,
cables and
pulleys. Replace
control
system
components
(push
rods, turnbuckles, end
fittings, castings, etc.) that have
bulges, splits, bends,
or
cracks. Check control
cables, pulleys,
and
associated equipment
for
condition, attachment, alignment, clearance,
and
proper
operation. Replace
cables that have broken strands
or
evidence of
corrosion. Check cables
for proper tension.
5.
CONTROL SURFACES Check for
deformation, cracks and
security.
Check for loose
or
missing rivets.
Check for freedom of
movement and
travel limits. Check for security of hinges
and bond cable.
6. TRIM
TABS AND
ACTUATORS Check for
security and
wear.
Check
allowable free play
as
outlined in
Chapter
27 of this Maintenance Manual.
Check
hinges
and trim tab actuator for
security and
wear.
Check trim tabs
for cracks and control rods for attachment. Lubricate the trim tab hinges
as
outlined in
Chapter 12-20-00
of this Maintenance
Manual.
7.
STATIC PORTS Check for
obstruction and clean
as
necessary.
8.
PLUMBING Check for
leakage,
cracks, chafing,
condition and security.
9.
ELECTRICAL WIRING AND
EQUIPMENT Inspect
for chafing, damage,
security
and attachment.
10.
STATIC LINES
Check condition of static lines and drain.
11.
ASSIST STEP
Inspect
for
condition and attachment.
12.
ANTENNAS Check for condition and
security.
13.
SCUPPER DRAINS Check that the
drain guards
are
open
facing aft and
drain holes
are
free from
obstruction.
14.
AFT
BULKHEADS (F.S.
257.6 and F.S. 271.92;
TJ-3 thru TJ-141,
TK-1 thru
TK-68) Inspect
for possible
cracks in the
bulkheads
at the horizontal
stabilizer stub spars. Refer to
Beech Service Instruction No. 0990, Rev. 1
or
subsequent
for
specific instructions.
15.
OXYGEN (TJ-82,
TJ-86 and After,
and TK-85 and After) Inspect the
oxygen
cylinder and
valves for condition and security of attachment.
Check
the valves for proper
operation.
H.
MAIN GEAR AND BRAKES
MECH
INSP
L R
1.
BRAKES, LINES, LINING AND
DISCS Check for condition,
wear
and
security.
Check lines for chafing
and signs
of leakage
or
cracks. Check discs
for
wear or
warping.
Check brake discs for cracks.
2.
WHEELS AND TIRES
Check
wheels for cracks and tires for wear,
damage,
condition and proper inflation. Check wheel bearings
for condition
and
wear.
Jun
2 8 / 0 2 P a g e 212
5-20-00