Nosesection - Raytheon BEECH BARON 58P Maintenance Manual

RaytheMI
Aircraft
BEECH BARON 58P AND BARON 58TC MAINTENANCE MANUAL
1 GO-HOUR INSPECTION (CONTINUED)
E. CABIN AND BAGGAGE COMPARTMENT (Continued) MECH
INSP
22. EMERGENCY EXIT HATCH (TK-1 and After) Check the emergency
release handle
and latch assembly for proper operation. Check that the
hatch
moves
out
freely.
Check the complete hatch assembly for condition
and all moving
parts
for proper operation. With the hatch
installed, check for
proper
latching
and seal.
Safety
the
emergency
exit with 0.020 inch
diameter copper wire after
opening.
23.
STATIC SYSTEM
Check and drain
water
from the static lines.
24. CONTROL COLUMN (TJ-436, TJ-444 and After; TK-147 and
TK-151)
Inspect
the control column
U-joint roll pins and
ensure
they
are
not
backing
out.
F.
NOSESECTION
1.
SKIN
Inspect
skin for
corrosion, condition, and loose
or
missing rivets. If
damage
is
found,
check
adjacent
structure.
2. STRUCTURE Check for corrosion, cracks, loose
or
missing rivets, and
concealed damage.
3.
RADAR ANTENNA COVER Check the
fiberglass
for
security, attachment
and cracks.
4. BATTERY Inspect for dean, tight connections and
correct
fluid level. Add
distilled
water
as
required. Inspect
vent
hose
at
battery box for obstructions.
The battery box should be washed
out
thoroughly and dried each time the
battery
is removed and
cleaned.
5.
BRAKE FLUID RESERVOIR Check reservoir for
security, attachment,
open
vent,
proper fluid level and for leaks.
6.
ELECTRICAL WIRING AND EQUIPMENT
Inspect
electrical
wiring and
associated equipment and accessories for condition, fraying, and
attachment.
7.
HEATER FUEL SYSTEM Check lines for connection and chafing.
8.
HEATER DUCTING AND WIRING Check security and chafing.
9. OXYGEN (TK-1 thru TK-84) Inspect the oxygen cylinder and valves for
condition and security
of attachment. Check the valves for proper operation.
10.
BAGGAGE DOOR Check for condition and proper latching.
G. REAR FUSELAGE AND EMPENNAGE
1.
SKIN Check for deformation, cracks and obvious damage.
Check for loose
or
missing rivets. If damage is found,
check adjacent
structure.
2.
STRUCTURE
Inspect
the
two most
aft bulkheads for
cracks, distortion,
loose rivets
or
other obvious damage.
3.
CONTROL CABLE SEALS
(TJ-3
and After) Check for condition, security,
cleanliness and lubrication.
nns
5-20-00
211