Channel/Scan - Icom IC-F5400DP Series Operating Manual

6
MENU SCREEN

Channel/Scan

C.Tone CH Select
In the Analog mode
Sets the Continuous tone channel� (p� 3-5)
Compander
In the Analog mode
Turns the Compander function ON or OFF�
This function reduces noise components on the
transmit audio for clear communication�
Priority A CH
Selects the Priority A channel� (p� 3-4)
Prio A (Rewrite)
Sets a current channel as the Priority A channel�
(p� 3-5)
Priority B CH
Selects the Priority B channel� (p� 3-4)
Prio B (Rewrite)
Sets a current channel as the Priority B channel�
(p� 3-5)
CC CH Select
In the Digital mode (Conventional only)
Sets the CC channel� (p� 3-6)
RF Power
Selects the output power for each channel�
• Options: Low 1, Low 2, High
L "Low 1" is the lowest power level, and "High" is the
highest power level�
L Lower output power during short-range communications
may reduce the possibility of interference to other
stations�
Scan Tag
Sets or clears a Scan tag to or from a channel in a
Scan list� (p� 5-6)
Scan List
Sets a Scan list to be scanned� (p� 5-4)
Scan Start/Stop
Starts or cancels a Scan�
A Scan checks for signals on each channel and stops
when a signal is received�
Scramble/Encrypt
In the Analog mode
Turns the Voice Scrambler function ON or OFF�
This function enables private communication between
stations using a Scramble code�
L The same Scramble code must be set in all stations to
communicate�
In the Digital mode
Turns the Encryption function ON or OFF�
This function enables private communication between
stations using an Encryption Key and Key ID�
L The same Encryption Key and Key ID must be set in all
stations to communicate�
Talk Around
Turns the Talk Around function ON or OFF�
The Talk Around function equalizes the transmit
frequency to the receive frequency, for direct
(Simplex) communication�
Zone Select
Selects a Zone� (p� 3-3)
6-9