Icom IC-F5400DP Series Operating Manual page 15

2
PANEL DESCRIPTION
Function display (for the Mobile type transceiver)
z LCD type
q
NOTE: The screen
capture is an example
The displayed position
of each icon may differ,
depending on the
function being used
D Icon Area
Indicators
q SIGNAL STRENGTH INDICATOR
Displays the relative received signal strength
w CLOCK
Displays the current time
L "AM" or "PM" is displayed beside the time display
when the 12 hour display format is selected
L "--:--" is displayed instead of the current time when the
internal clock is not set
Icons
The following icons are displayed in the Icon Area
POWER ICON
• "L1" is displayed when the output power is set to Low
• "L2" is displayed when the output power is set to Mid
• "H" is displayed when the output power is set to High
AUDIBLE ICON
Displayed when the channel is in the 'audible'
(unmute) mode
MESSAGE ICON
• Blinks after Messages (Message or Status Message)
have been received
• Stops blinking when the screen is changed, or any
key is pushed, but is displayed if unread messages
are still in the Message memory
• Disappears when all messages in the Message
memory have been read
BELL ICON
Displayed when a matching signal is received,
depending on the presetting
SCAN ICON
• Displayed when a scan is paused
• Blinks while scanning
SCAN TARGET CHANNEL ICON
Displayed when the channel is selected as a scan
target channel
SCRAMBLER ICON
In the Analog mode
Displayed when the Voice Scrambler function is ON
In the Digital mode
• Displayed when the Voice Encryption function is ON
• Blinks when decoding an encrypted signal
GPS ICON
• Displayed when a valid position data is received
• Blinks when searching for satellites or calculating
position data
L Depending on the presetting, the GPS icon is not
displayed
RECORD ICON
• Displayed when the Record function is ON
• Blinks while recording the audio
L Depending on the presetting, the Record icon is not
displayed
TALK AROUND ICON
Displayed when the Talk Around function is ON
PHONE ICON
Displayed when the transceiver is connected to a
telephone network on the selected channel
SITE LOCK ICON
Displayed when the Site Lock function is ON
LONE WORKER ICON
Displayed when the Lone Worker function is ON
NOISE CANCEL ICON
Displayed when the Noise Cancel function is ON
SURVEILLANCE ICON
Displayed when the Surveillance function is ON
2-7
w
Icon Area