Icom IC-F5400DP Series Operating Manual page 29

2
PANEL DESCRIPTION
Assignable Software key functions
D For keys and keypads (Continued)
Category: Trunking
Call Back
In the Digital mode
Push to turn the Call Back function ON or OFF
The Call Back function automatically sends back an
acknowledgement (Call Back) to the caller station
after receiving an Individual call
Site Select
In the Digital mode
Push to display the "Site Select" screen Then, push
[Up] or [Down] to select a site number
After selecting, push [OK] to set the selected site
• The selected site is locked
Site Lock
In the Digital mode
Push to turn the Site Lock function ON or OFF
L When this function is turned ON, the transceiver cancels
resuming a roaming scan, and stays on the current site,
regardless of the error rate
Roaming Request
In the Digital mode
z Push to start or resume a roaming scan, regardless
of the error rate
z When the Site Lock function is turned ON, push to
resume a roaming scan
Category: Functions
Light
Push to turn ON the backlight for about 5 seconds,
even if the backlight setting is OFF
Lock
Hold down for 1 second to turn the Key Lock function
ON or OFF
L All assignable keys except the following are electronically
locked: [Monitor], [Light], [Lock], [Call], [Emergency], and
[Surveillance] Also, [PTT] and [Power] are usable
Sp. Func 1, Sp. Func 2, Sp. Func 3,
Sp. Func 4, Sp. Func 5, Sp. Func 6
Sp Func 1 through Sp Func 6 are reserved for PC
commands
Public Address (For the Mobile type transceivers)
Push to activate the Public Address (PA) function
And then, speak into the microphone while holding
down [PTT]
L When the PA function is activated, the audio output can
be separately controlled from the transceiver by pushing
[Up] or [Down]
NOTE: This function is usable when an external
unit, such as a audio amplifier, speaker, and so on is
connected to the D-Sub 25 pin connector
RX Speaker (For the Mobile type transceivers)
Push to turn the RX Speaker function ON or OFF
L When the RX Speaker function is turned ON, the
received audio can be heard through an external speaker
that is connected to the D-Sub 25 pin connector
NOTE:
• This function is usable when an external speaker is
connected to the D-Sub 25 pin connector
• This function is useful when a user is out of the
vehicle
• The audio output level is linked to the transceiver's
volume control
Hook Scan (For the Mobile type transceivers)
Push to temporarily turn the On Hook Scan function
ON or OFF
2-21