Table of Contents
Advertisement
11
Bluetooth
®
OPERATION
Turning ON the Bluetooth
D For the Portable Non-display types and Mobile Segment types (Continued)
Mobile:
Step 1: Entering the Bluetooth
1� Turn OFF the transceiver�
2� While holding down [F2] and [F3], turn ON the
transceiver� Continue holding down [F2] and [F3]
for about 3 seconds�
• 2 beeps sound�
Step 2: Entering the Pairing mode
L See the Bluetooth
®
device's instruction manual for
details�
Step 3: Turning ON the Bluetooth
3� After the headset has entered the Pairing mode,
hold down [F1] for 1 second to enter the Set
mode�
4� Push [F2] or [F3] to select "b0�"
5� Push [Up] to turn ON the Bluetooth
• The transceiver automatically enters the Pairing mode,
and begins searching for a Bluetooth
• While searching, the status indicator quickly blinks
blue�
L If the status indicator does not blink after pushing
[Up], the transceiver has not entered the Bluetooth
Set mode� In that case, do steps 1 and 2 again�
L If the transceiver has been paired with a Bluetooth
headset before, the transceiver does not start
searching� In that case, the transceiver and the
headset are automatically connected�
Step 4: Pairing with a headset
When a headset is found, the transceiver pairs with it�
• After the transceiver and the headset pairing has
succeeded, the Status indicator slowly blinks blue 3 times�
In that case, the connection to the headset has also
succeeded�
L T hetransceiversearchesforaheadsetfirst.After
searching for a headset, the transceiver will start
searching for a data device� To skip searching for a data
device, push [PTT] on the headset�
L If the Bluetooth
®
connection fails, the Status indicator
slowly blinks red 3 times� To search for a headset again,
push [Down] to turn OFF the Bluetooth
push [Up] to turn it ON again�
®
function
Set mode
®
(Transceiver)
(Bluetooth
®
device)
®
function
(Transceiver)
®
function�
®
headset�
(Transceiver)
®
function, then
Step 5: Pairing with a data device
1� When a data device is found, the transceiver pairs
with it�
• After the transceiver and the data device pairing has
succeeded, the Status indicator slowly blinks blue 3
times� In that case, connection to the data device has
also succeeded�
L If the Bluetooth
slowly blinks red 3 times� To search for a PC again,
push [Down] to turn OFF the Bluetooth
then push [Up] to turn it ON again� The transceiver
automatically tries to connect�
2� Hold down [F1] for 1 second to exit the Set mode�
3� Turn OFF the transceiver, then turn it ON again to
normally operate the transceiver�
®
TIP: To turn OFF the Bluetooth
®
[Down] when "b0" is selected in the Set mode�
11-5
®
connection fails, the Status indicator
[Up]
Power key
F1
F2
F3
[F1] [F2] [F3]
[Down]
®
function, push
(Transceiver)
®
function,
Advertisement
Table of Contents
