Icom IC-F5400DP Series Operating Manual page 115

8
BIIS 1200 SYSTEM OPERATION
Transmitting a call
D Transmitting a Status message (Continued)
<Key operation>
Portable: For the Ten-key and the Simple key types
Mobile: For the LCD types
Using [Status]:
1� Push [Status] to display the "Status" screen�
2� Push [Up] or [Down] to select a Status Message,
then push [PTT] to transmit it�
L "Success" is displayed after receiving an
acknowledgement from the target station�
L "Failed" is displayed if the target station does not
send back an acknowledgement�
Portable: For the Non-display types
Mobile: For the Segment types
Using [Status]:
Hold down [Status] for 1 second to transmit the preset
Status Message�
TIP: This operation is enabled only when [Selector]
is set to "Status" using the programming software�
NOTE: The status message can be automatically
transmitted when:
• The transceiver is turned ON�
L Set the 'Power ON Status23' item to 'Enable�'
• The transceiver is turned OFF�
L Set the 'Power OFF Status19' item to 'Enable�'
8-8