Table of Contents
Advertisement
6.10 TO REMOVE A BLOCKAGE FROM CUTTING UNITS_________________________
It is important to note: there will be remaining hydraulic pressure within the system that can cause the
cutting cylinder to rotate when the obstruction is removed. Therefore keep your hands, feet and
clothing away from cutting units at all times.
1)
Disengage the power to the cutting units with the cutting unit switch.
2)
When all rotation has stopped, lift the cutting units into the transport position.
3)
Move the machine to a flat level surface.
4)
Set the parking brake.
5)
Move the throttle control lever to the slow position.
6)
Turn the ignition key to the OFF position and remove the key.
Make sure correctly selected PPE is worn before you clear the obstruction.
8)
Use the Ransomes Jacobsen "Cutting Unit Tool" part number 4184540, see below or stout stick, put
into the cutting cylinder between the blades.
9)
Rotate the cylinder with either the "Cutting Unit Tool" or "Stout Stick" until the obstruction has been
removed.
10)
Inspect all the cutting surfaces for damage, when necessary replace the damaged components.
CAUTION
NOTE
OPERATION 6
en-49
Advertisement
Table of Contents
