Table of Contents
Advertisement
5.2.N, P, RLIFT/LOWER SWITCH'S ____________________________________________
N.
Right Hand Wing cutting unit
P.
Front and centre cutting units
R.
Left Hand Wing cutting unit
To lower the cutting unit move the switch lever forward.
To raise the cutting unit move the switch lever rearwards
NOTE:
If the cutter is engaged when the unit is lowered the green led will illuminate when the
unit is below 400mm from the ground.
The yellow PTO LED will illuminate when the cutter switch is engaged
If the lever is pulled momentarily rearwards the unit will raise to the cross cut position and
continue to rotate for 3 seconds. Lowering the unit within 3 seconds will let the blade continue rotating without stopping.
If the lever is held and the unit lifts above the cross cut position the unit will continue to lift and the blade will stop rotating at
400mm. The lift will stop when the lever is released.
5.2.S, T, W, X
S
PTO engaged
T
Right hand wing cutting unit in cutting position.
W
Front and centre hand cutting unit in cutting position.
X
Left hand wing cutting unit in cutting position.
5.2Y
WEIGHT TRANSFER BUTTON
The button will transfer weight by the hydraulic system between the cutting units and
the drive wheels.
The weight transfer only operates while the button is depressed.
The cutter switch needs to be engaged for this function to operate.
INDICATOR LAMPS _______________________________________
5 CONTROLS
R
P
N
S
T
W
X
en-25
Advertisement
Table of Contents
