Stereo Line In Devices; Headphones; Telephone Lines; Serial Port Devices - Fujitsu 985Tx User Manual

S e c t i o n F o u r
of your notebook. Make sure the plug is aligned
and push it into the jack until fully seated.
(See Figure 1-6 on page 7.)

STEREO LINE IN DEVICES

Make sure that your stereo line in audio device,
a cassette recorder, for example,is equipped
with an 1/8"(3.5 mm) stereo mini-plug. The
stereo lin in jack is on the right side of your
notebook. Make sure the plug is aligned and
push it into the jack until fully seated.
(See Figure 1-6 on page 7.)

HEADPHONES

Make sure that your stereo headphones are
equipped with an 1/8"(3.5 mm) stereo mini-
plug. The headphone jack is on the right side of
your notebook. Make sure the plug is aligned
and push it into the jack until fully seated.
(See Figure 1-6 and page 7.)

TELEPHONE LINES

To attach a telephone line to the internal modem
open the rear panel connector cover or, with the
cover closed,slide the panel in the connector
cover slightly open to reveal the RJ-11 jack.
112
Plug one end of the telephone cable into the
telephone line outlet.Orient the telephone
cable with the release latch on the connector up.
Push it into the j ack until it clicks and latches.
(See Figure 1-7 on page 8.)
C A U T I O N
The internal modem is not intended for
use with Digital PBX systems. Do not
connect the internal modem to a digital
PBX as it may cause serious damage to
the internal modem or your entire note-
book. Consult your PBX manufacturer's
documentation for details. Some hotels
have Digital PBX systems. Be sure to find
out BEFORE you connect your modem.

SERIAL PORT DEVICES

To connect an RS-232 device to the serial port
on the rear panel of your notebook, be sure that
the connector is the right size and aligned,then
push in until it is fully seated. When it is seated,
tighten the hold-down screws, one on each end
of the connector. (See Figure 1-7 on page 8.)

PARALLEL PORT DEVICES

To connect a parallel interface device to the par-
allel port on the rear panel of your notebook,
be sure that the connector is the right size and
aligned, then push in until it is ful ly seated.
When it is seated tighten the screw locks on
either end of the connector. (See Figure 1-7
on page 8.)

USB DEVICES

When installing a device on either of the USB
ports on the rear panel of your notebook, be
sure that the connector is the right size,aligned,
and fully seated. (See Figure 1-7 on page 8.)