Theft Prevention Lock; Mouse; Keyboard; Microphone - Fujitsu 985Tx User Manual

gently pulling on the bottom edge of the
cover and lifting it up.
4. Align the connector of the adapter cable with
the connector towards the body of your note-
book. (Figure 4-13.)
5. Insert the connector firmly into the port on
your notebook until it clicks.
6. Align the connector of the MIDI device and
the adapter cable connector.
7. Push the connectors together until seated and
then tighten the screw locks on either side of
the connectors.
To disconnect a MIDI/Joystick Device:
1. Close all files and exit all applications
2. Turn off power to your notebook, close the
display and remove the AC adapter.
(See pages 24–25 for more information.)
3. Squeeze the releases on the sides o f the MIDI
device connector together. (The connector is
next to the body of your notebook.)
(Figure 4-13.)
U s e r I n s t a l l a b l e
4. Pull the connector free.
5. Close the port cover on your notebook by
pushing it down and pressing it into the side
of your notebook until it latches.
6. Unscrew the locking screws on either side o f
the connectors for the MIDI device and the
adapter cable.
7. Pull the adapter cable free of the
MIDI device.

THEFT PREVENTION LOCK

A physical security system lock can be installed
on the right side of your notebook. (See Figure
1-5 on page 7 for the location of the lock slot.)
Simply insert the key end of your security
system in the slot, rotate 90 degrees and lock.
(See Figure 1-5 on page 7.)

MOUSE

Make sure the connector on your device is the
correct PS/2 type. The PS/2 ports are on the
right side of your notebook. Align the arrow on
the connector to point to the bottom of your
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
F e a t u r e s
notebook and push it in until the connector
seats.A mouse may be installed and will be
automatically recognized by your notebook
without restarting or changing setups.
(See Figure 1-6 on page 7.) A mouse may
be installed in either PS/2 port.

KEYBOARD

Make sure the connector on your device is the
correct PS/2 type. The PS/2 ports are on the
right side of your notebook. Align the arrow on
the connector to point to the bottom of your
notebook and push it in until the connector
seats.A keyboard or numeric keypad may be
installed and will be automatically recognized
by your notebook without restarting or
changing setups. (See Figure 1-6 on page 7.)
A keyboard or numeric keypad may be installed
on either PS/2 port.

MICROPHONE

Make sure that your mono microphone is
equipped with an 1/8"(3.5 mm) mono mini-
plug. The microphone jack is on the right side
111