Fujitsu 985Tx User Manual page 137

Symptom
The CD-ROM Access indicator on the Status
Indicator panel blinks at regular intervals when
no CD is in the tray or the CD-ROM drive is
not installed.
T r o u b l e s h o o t i n g
Possible Cause
4. CD-ROM tray is not latched shut.
5. Setup utility is set to something other
than CD-ROM for the IDE Adapter
Master 1 Controller.
6. Wrong drive designator was used for
CD-ROM in the application.
7. Windows CD auto insertion function
is disabled.
1. The Windows CD auto insertion function
is active and is checking to see if a CD
is ready to run.
L i f e B o o k 9 0 0 S e r i e s f r o m F u j i t s u
Possible Solution
4. Push on the front of the CD-ROM tray
until it latches.
5. Revise BIOS settings to set IDE Adapter 1
Master correctly. (See Main menu and
IDE Adapter submenu pages 59–63
for more information.)
6. Verify the drive designator used by the
application is the same as the one used by
the operating system. When the operating
system is booted from a CD-ROM drive
designations are automatically adjusted.
(See Boot Options submenu on pages 64–65.)
7. Start the CD from the desktop or applica-
tion software or re-enable the Windows CD
auto insertion function. (See CD-ROM
Drive Access Indicator on pages 21–22 for
more information.)
1. This is normal. You can disable this
function if you wish. (See CD-ROM Drive
Access Indicator on pages 21–22 for
more information.)
129